head bolt torque spec

**wozzer** · 10-03-2010, 05:25 PM

as above for my DOHC 1.4i 16v sport.
iv tryed reading the haynes manual but
i havnt got a clue

thanks lads

**Nige_Jones** · 11-03-2010, 06:38 PM

If your engine code is C14NZ 1993-1998 I think you'll need an angle guage and a torque wrench I think you satrt off tightening the bolts to 25Nm, then the guage to either 60 or 90 degrees, but id check a workshop manual tho.

**Kitson** · 11-03-2010, 06:41 PM

I can find out for you tomorrow mate

.

**wozzer** · 11-03-2010, 06:48 PM

Quote:

Originally Posted by Kitson

I can find out for you tomorrow mate

.

thanks pal engine code is X14XE

10-03-2010, 05:25 PM	#1
wozzer Gold Member Join Date: Jan 2010 Location: oldham Drives: corsa b sport Gender: Posts: 144 iTrader: (0) Thanks: 4 Thanked 4 Times in 4 Posts	head bolt torque spec needed please. as above for my DOHC 1.4i 16v sport. iv tryed reading the haynes manual but i havnt got a clue thanks lads __________________ THE PURPLE MONSTER Last edited by wozzer; 10-03-2010 at 05:42 PM..

11-03-2010, 06:41 PM	#3
Kitson Gold Member Join Date: Mar 2008 Location: Tamworth - Staffordshire Drives: Corsa SXI - 1.2 16v Gender: Posts: 3,353 iTrader: (1) Gallery: 7 Thanks: 110 Thanked 66 Times in 64 Posts	I can find out for you tomorrow mate . __________________ >Project Thread >Photo Album

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

11-03-2010, 06:38 PM	#2
Nige_Jones Gold Member Join Date: Jan 2010 Location: Holywell Drives: Corsa B 1.0 12V Club Gender: Posts: 52 iTrader: (0) Thanks: 6 Thanked 1 Time in 1 Post	If your engine code is C14NZ 1993-1998 I think you'll need an angle guage and a torque wrench I think you satrt off tightening the bolts to 25Nm, then the guage to either 60 or 90 degrees, but id check a workshop manual tho.

Remove advertisements Sponsored links

Remove advertisements Sponsored links