All Corsa Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Hi folks

Just about to start putting the head back on wifey's 1.0L Agila at last after getting all the parts required and just been reading the Haynes manual again and it says I need some silicon sealant part no. 90-543-772 (or equivalent).

What I would like to know is this a special silicon sealant or can I use general purpose stuff (bathroom sealer) or even sikaflex or Loctite 518 Flange sealant for aluminium parts, or do i need to use the right stuff (or equivalent) and should I be able to get some from my local Motorfactor?

Cheers

Jez
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top